Here Comes Santa!

This is the second of my special requests for LeAnn. Hope you like him LeAnn, I think he is my favorite so far.

To make him you will need,one Top Note die cut in blush blossom, and one in whisper white. just less than half a red Top Note die cut, the same for another white Top Note die cut, a bracket cut from the Top Note die (tutorial here), seven small white scallop die cuts from the Basket and Blooms XL Bigz die, one white scallop circle punch, one red small pennant die cut, two 1" white circle, two 3/4" black circles and one 1" blush blossom circle cut in half, half a round tab punch in blush blossom and a box made from blush blossom as from the Frankie tutorial.
Emboss all white pieces except eyeball circles, with a swirly embossing folder. Sponge all edges, except eyeball pieces, with chocolate chip ink.

using the large oval punch, punch out half an oval from the inside middle section of your half Top Note white piece. This will be his beard. and the oval will be his mouth.

Adhere to bottom half of Blush blossom Top Note die cut.

Then over that, attach bracket piece for mustache, be sure to leave a small opening for his mouth.

Attach nose to center of face and then sponge on some light pink of red, for rosy cheeks and nose.

Assemble and attach eyes as in Frankie tutorial.

To make the hat, I used my scallop border punch to narrow the width of the pennant die cut, going straight up the sides on both sides. Then using your fingers and thumb, gently curve the top over and to the left or right( but off center).

Attach to top of Blush Blossom die cut, just above the eyes.

With four of your smaller scallop circles, attach them to the edge of the hat.

Then attach a smaller scallop circle to the center of the larger scallop circle.

Attach to the top of the pennant die cut and to the part that is curved down over the face.

Add a dimensional to the back of the scallop circle.

Then adhere to Santa's face just above his eye.

Attach your partial red Top Note die cut to the top half of your white Top Note die cut. Attach remaining three small scallop circles to the lower edge of the red section.

Attach your front and back pieces to your box.

Then add some wire as in the Frankie tutorial.

And then there were two....

I have to say I was disappointed no one seemed to like Rudolph as much as my other characters. I think he is cute.

I have one more character to share and I think I will be done with them. I think!

Thanks,